POF¡¢PET¡¢D955¡¢PVC shrink film
and D955 environmental protection shrink film (bags, tubes) are low
density (0.92) and five-layer co-extruded produced and have good
effect in packaging irregular products. They achieve international
environmental protection standard and are subjected to America and
Europe environmental protection quality system.
a. Strong toughness: Obvious in sealing; No opening
when shrinking; High molecular structure.
b. High transparency: No eutectic point; No pattern; High glossiness
(physical value 125).
c. High shrink ratio: 120-200¡æ (Lateral 65%, Vertical above 65%);
Depend on environment temperature
d. Sealing temperature: 200-290¡æ. Variable in different thickness.
e. Always keep soft at low temperature (below -20¡æ); No scratching
at welding joint after shrinking well.
f. High friction force: Wear resistant, penetration resistant and
high toughness on product surface after packaging. Suitable for
product packaging in all industries. Available to roll material, rim
charge and bag material (arc bags, special bags, flat bags, square
bags and square bottom bags).
Width: 2-35¨•inch (30mm-890mm)
Length: Roll material 500M .1000M.1332M£¬1067M,800M
Bag length: 50-6000mm
Storage temperature: Below 90F
Available SGS report.
PVC common heat shrink film is available to package product
requesting different kinds. No over-standard in heavy metal;
Relative low shrink temperature and high shrink speed; Usually good
effect is achieved at 80-120¡æ. This product has high transparency,
clearness and high glossiness. It is easy shrink for instant heating
and suitable for all shrinkers. This shrink film is widely applied
and suitable for product packaging without high requestion and low
cost, such as wooden products, crafts gift, candle, manual book,
printing and electronics, etc. Also, it is available to make flat
bags, arc bags, special bags and triangle bags. Fastening packaging,
beautiful and burning resistant. No decolor at printing.
Length: 250M-500M -1000M (Up to customer)
Shrink ratio: Vertical 3%~50%; Lateral: about 55%; Shrink
temperature: 80~150¡æ in normal machine running;
Storage temperature in transport: About 25¡æ
Disadvantage: Fragile, hard (obvious at -20¡æ), relative bad sealing
effect, pungent odor in burning.
Available SGS report.